| SIMATIC DP, INTERFACE DP/PA-LINK A. ET200M IM153-2 HF FOR EXPANDED TEMPERATURE RANGE FOR MAX. 12 S7-300 MODULES, WITH REDUNDANCY, TIME STAMPING FIT FOR ISOCHRONE MODE NEW FEATURES: 12 MODULES / STATION SLAVE INITIATIVE FOR SWITCHES AND DRIVEES EXTENDED DATA FOR HART SECON- DARY VARIABLES OPERATON WITH 64PT MODULES EXTENDES TIMESTAMPS WITH 32 SIGNALS / SLOT |
|
General information |
Vendor identification (VendorID) | 801Eh |
Supply voltage |
24 V DC | Yes |
permissible range, lower limit (DC) | 20.4 V |
permissible range, upper limit (DC) | 28.8 V |
permissible range (ripple included), lower limit (DC) | 20.4 V |
permissible range (ripple included), upper limit (DC) | 28.8 V |
External protection for supply cables (recommendation) | 2.5 A |
Mains buffering |
Mains/voltage failure stored energy time | 5 ms |
Input current |
Current consumption, max. | 600 mA |
Rated value at 24 V DC | 650 mA |
Inrush current, typ. | 3 A |
I²t | 0.1 A²·s |
Output voltage |
Rated value, 5 V DC | Yes |
Output current |
for backplane bus (5 V DC), max. | 1.5 A |
Power losses |
Power loss, typ. | 5.5 W |
Address area |
Addressing volume |
Outputs | 244 byte |
Inputs | 244 byte |
Hardware configuration |
Number of modules per DP slave interface, max. | 12 |
Time stamping |
Accuracy | 1 ms; 1ms at up to 8 modules; 10ms at up to 12 modules |
Number of message buffers | 15 |
Messages per message buffer | 20 |
Number of stampable digital inputs, max. | 128; Max. 128 signals/station; max. 32 signals/slot |
Time format | RFC 1119 |
Time resolution | 0.466 ns |
Time interval for transmitting the message buffer if a message is present | 1000 ms |
Time stamp on signal change | rising / falling edge as signal entering or exiting |
Interfaces |
Interface physics, RS 485 | Yes |
Interface physics, FOC | No |
PROFIBUS DP |
Node addresses | 1 to 125 permitted |
Automatic detection of transmission speed | Yes |
PROFIBUS DP, output current, max. | 70 mA |
Transmission procedure | RS 485 |
Transmission rate, max. | 12 Mbit/s |
SYNC capability | Yes |
FREECE capability | Yes |
Direct data exchange (slave-to-slave communication) | Yes; Sender |
PROFIBUS DP | 9-pin sub D |
1st interface |
DP slave |
GSD file | SI0480E.GSG |
Automatic baud rate search | Yes |
Communication functions |
Bus protocol/transmission protocol | PROFIBUS DP to EN 50170 |
Isolation |
Isolation checked with | Isolation voltage 500 V |
Degree and class of protection |
IP20 | Yes |
Ambient conditions |
Operating temperature |
Min. | -25 °C |
max. | 60 °C |
Air pressure |
Operating altitude above sea level, max. | 3000 m |
Dimensions |
Width | 40 mm |
Height | 125 mm |
Depth | 117 mm |
Weight |
Weight, approx. | 360 g |
Status | Apr 9, 2012 |